全校師生：
我校定于2018年04月29日舉辦研究生靈犀學術殿堂——Arvid Naess教授報告會，現將有關事項通知如下：
1.報告會簡介
報告人：Arvid Naess教授
時間：2018年04月29日（星期日）上午10:30
地點：友誼校區國際會議中心第一會議室
主題：Non-linear 6D response statistics of a rotating shaft subjected to colored noise by path integration
內容簡介：
a Jeffcott-type rotor with non-linear restoring force, under uniaxial colored noise excitation. The latter type of dynamic system is of wide use in stability studies of rotating machinery.
System response statistics are studied by applying the path integration (PI) method. The Jeffcott rotor response statistics are then obtained by solving the Fokker–Planck-Kolmogorov (FPK) equation for a 6D dynamic system. The resulting response probability distributions can serve as an engineering input for a wide range of design issues, e.g. estimates of characteristic values, extreme value statistics and system reliability. Assessment of transverse random vibrations of shafts in rotating machinery may be of practical importance for applications with substantial environmental dynamic loads on supports, particularly in transport/vehicle engineering. Colored noise is a step forward compared to white noise excitation forces, but it raises the mechanical system dimension from 4D to 6D.The major advantage of path integration, relative to direct Monte Carlo simulation, is that path integration yields high accuracy in the probability distribution tail. Improved implementation of the PI algorithm was applied, specifically, the fast Fourier transform (FFT) was used to simulate the additive noise of the dynamic system. PI was accelerated by using a Monte Carlo based estimate of the joint PDF as a initial input. Finally, the key feature of this work is the advance to 6D problems, where very little PI research has been done. The obvious reason is of course the formidable computation load arising from decent 6D mesh. In the presentation a practical solution to the latter challenge is discussed, enabling 6D PI calculation on an ordinary desktop within a reasonable amount of time. Using modern computational hardware with a decent GPU (Graphic Processing Unit) will significantly facilitate 6D calculation, making it accessible for engineering problems.
2.歡迎各學院師生前來聽報告。報告會期間請關閉手機或?qū)⑹謾C(jī)調至靜音模式。
黨委研究生工作部
理學院
2018年04月27日
報告人簡介
Arvid Naess教授為挪威科技大學（NTNU）教授、挪威皇家科學（技術）院院士、挪威皇家科學與文學院院士、美國土木工程學會2010年“弗洛登瑟爾獎”得主。主要研究方向概率統計、隨機振動和結構可靠性等。目前，Arvid Naess教授擔任多個國際期刊的副主編和編委，發表論文100余篇。
